Searching for Whole House Repiping often follows another rusty glass of water, a shower that loses pressure when the washer starts, or damp patches beneath a wall. The Plano Plumber can trace whether aging galvanized, copper, or polybutylene supply lines are restricting flow instead of treating only the visible symptom. Banging pipes and recurring pinhole leaks matter, too, because pressure surges can enlarge a weak section and send water into framing. You can also find out more about the company.
Low pressure at one faucet can sometimes wait for an aerator or cartridge check, especially if the water is clear and the water meter is still. Discoloured water at several fixtures, wet drywall, or no hot water combined with a leaking water-heater connection needs prompt assessment. Shut off the main valve if water is actively spreading. Slow drains usually involve drain piping rather than supply lines, but repeated backups warrant a camera inspection before walls are opened.
Material and layout set the starting point. A house with galvanized pipe, polybutylene tubing, or repeated copper pinhole repairs may need new hot and cold branches, while a newer manifold with one failed line may not. Previous slab-leak reroutes, patched drywall, and accessible attic space change the route a plumber can use. Backflow Testing may also reveal a cross-connection or failed assembly that should be corrected separately from the supply-line diagnosis.
A pressure test, fixture-by-fixture check, and inspection of exposed pipe help distinguish a whole-house issue from a local repair. Running new PEX through an attic can reduce wall openings, but it may require insulation where temperatures fluctuate. Routing pipe through walls can create shorter runs and faster hot water, yet it involves more drywall access. A straightforward layout may take several working days, while hidden corrosion or limited access can extend the plan.
The main cost difference is not simply square footage; it is the number of fixtures, pipe runs, and access points. A compact one-bathroom home with an open attic requires far fewer valves, fittings, and drywall openings than a two-story home with three or four bathrooms. Copper generally costs more in material than PEX, while PEX may reduce labor on long runs. A larger, multi-bath layout can require roughly 1.5 to 2.5 times the labor and components of a smaller layout. Contact Us for a free, no-obligation quote.
Before you contact a plumber for comparison, ask for a written estimate that separates pipe material, shutoff valves, fixture connections, access openings, testing, permit-related work if required, and drywall or paint restoration. It should also state what is excluded, such as drain replacement or water-heater replacement. The final scope can move if a wall cavity contains damaged framing, an unmarked line, or more corroded branches than the visible pipe suggested.
For many occupied homes, installing the new water lines takes about two to five working days, while a larger two-story layout or difficult routing can take a week or more. Water is usually shut off only during planned tie-ins, but individual bathrooms or the kitchen may be unavailable at different points. Plumbers first map fixtures, protect floors, open limited access areas, then install hot and cold branches before reconnecting faucets, toilets, and the water heater.
Some stages can look quiet because the work is happening inside an attic, wall cavity, or crawlspace. Pressure testing checks every new joint for leaks before the old pipe is abandoned or removed, and flushing clears air and construction debris from faucets. Delays can come from concealed pipe routes, damaged drywall, inspection scheduling, or waiting for a required valve or fitting. Restoration work may continue after the water service is back on.
THE PLANO PLUMBER
5360 Legacy Drive, Plano, TX 75024
(469) 838-3498
Hours of Operation
Open 24 Hours